[leaf-wisp] Re: wisp problem

TomĂĄĹĄ RychlĂ­k wrote:
> Hello! Can you help me?
> 
> I have the same problem as Jonathan, he wrotes:
> 
>  
> 
> Hi,
> 
> I'm having a problem with Wisp-dist.  I have the latest version of Wisp-Dist
> 
> and a Demarc Technologies card (as stated in as compatible in the
> 
> documentation).  However when loading the OS loads the card and hostap
> 
> drivers properly and I can change all the information but the bit-rate is
> 
> set at 2Mbps and I can't change it for the life of me.

The bitrate in case of access point does not make sense and is set to 
default. Actually the AP allows connection up to 11 mbps. You can 
check the RX/TX speeds of your clients by going into statistics.

> 
>  
> 
> Also When in AP mode (or in any mode) other cards can see the ESSID but
> 
> can't connect.  This is especially true in the AP mode as all scans show the
> 
> Linux box as being up and an AP but when they attempt to connect nothing
> 
> happens.  On the AP it doens't look like any packets even reach the network.
> 
> Can anyone help
> 

I can see two possible reasons:

1) IRQ routing problem
2) Incompatible firmware (not 1.5.6)

Both issues have been discussed on the list several times in the past.


-- 
Best Regards,
Vladimir Ivashchenko
ThunderWorx - www.thunderworx.com
Senior Systems Designer/Engineer



-------------------------------------------------------
This SF.Net email is sponsored by BEA Weblogic Workshop
FREE Java Enterprise J2EE developer tools!
Get your free copy of BEA WebLogic Workshop 8.1 today.
http://ads.osdn.com/?ad_id=4721&alloc_id=10040&op=click