Re: jhalfs pacman and blfs

On Tue, 2022-06-14 at 14:11 +0300, Yasin YILMAZ wrote:
> 
> 14.06.2022 00:32 tarihinde Pierre Labastie ([email protected] via alfs-
> discuss Mailing List) yazdı:
>  
> > On Mon, 2022-06-13 at 23:40 +0300, Yasin YILMAZ wrote:
> >  
> > > 13.06.2022 16:25 tarihinde Yasin YILMAZ ([email protected] via
> > > alfs-
> > > discuss Mailing List) yazdı:
> > >  
> > >  
> > > > This is great. Thanks however. 
> > > >  
> > > >  https://www.linuxfromscratch.org/alfs/ I pulled the git clone
> > > > git://git.linuxfromscratch.org/jhalfs.git jhalfs file again and tried
> > > > ALFS
> > > > again. This time I tried with only LFS + Pacman without BLFS, but it
> > > > still
> > > > gave an error as below.
> > > > 
> > > >  ---
> > > >  Building target 712-04-libcap
> > > >  [++++/make: *** [Makefile:721: 712-04-libcap] Error 2               ] 0
> > > > min. 4 sec
> > > >  make[1]: *** [Makefile:113: mk_CHROOT] Error 2
> > > >  make[1]: Leaving diretory '/mnt/lfs/jhalfs'
> > > >  ---
> > >  Despite the updated jhalfs files, I am getting the same error, namely the
> > > error below. 
> > >  
> > >  --- 
> > >  Building target 712-04-libcap 
> > >  [++++/make: *** [Makefile:721: 712-04-libcap] Error 2 ] 0 min. 4 sec 
> > >  make[1]: *** [Makefile:113: mk_CHROOT] Error 2 
> > >  make[1]: Leaving diretory '/mnt/lfs/jhalfs' 
> > Hmm, Have you copied the new pkgmngt/packageManager.xml.pacman to
> > pkgmngt/packageManager.xml (and same for pkgmngt/packInstall.sh.pacman to
> > pkgmngt/packInstall.sh)?
> > 
> > Pierre
> >  
> >  
> 
>  I want it so much the error looks different. 
>  I pulled the jhalfs files from git clone
> git://git.linuxfromscratch.org/jhalfs.git in this
> https://www.linuxfromscratch.org/alfs/ link and edited everything from scratch
> again and started the LFS + Pacman installation. 
>  
>  cp pkgmngt/packageManager.xml.pacman pkgmngt/packageManager.xml 
>  
>  and 
>  
>  cp pkgmngt/packInstall.sh.pacman pkgmngt/packInstall.sh 
>  
>  I applied the commands in the jhalfs folder with the lfs user. I started the
> process with the make command and while everything was running normally and
> well, I encountered the following error.
>  
> ---
>  Building target 803-glibc
>  [+++++++++++make: *** [Makefile:907: 803-glibc] Error 1               ] 39
> min. 10 sec
>  make[1]: *** [Makefile:113: mk_CHROOT] Error 2
>  make[1]: Leaving diretory '/mnt/lfs/jhalfs'
>  ---

I think I cannot guess the error this time. Could you attach
/mnt/lfs/jhalfs/logs/803-glibc-xxx, or at least the relevant part of it?

Or maybe I can try to guess (owing to the duration of the glibc build): you
might have ticked "Run testsuites", and then chosen 
"Flavour (Abort the build on the first test failure)"

If so, please retry with "Flavour (Don't stop on test failures)". A few glibc
tests (and a few others) error out, so the build cannot go past those if "Abort
the build on the first test failure" is selected.

Pierre

-- 
http://lists.linuxfromscratch.org/sympa/info/alfs-discuss
Unsubscribe: See the above information page