Re: Unable to set up transient service directory
| Newsgroups | gmane.linux.lfs.beyond.support |
|---|---|
| Message-ID | <[email protected]> |
On 6/13/25 3:49 PM, "Cliff mcDiarmid" ([email protected] via blfs-support Mailing List) wrote: > On Fri, 2025-06-13 at 07:29 +0000, Cliff mcDiarmid wrote: >>> On 6/12/25 2:15 AM, tjoen ([email protected] via blfs-support Mailing >>> List) wrote: >>> On 6/11/25 9:18 PM, "Cliff mcDiarmid" ([email protected] via >>> blfs- >> support Mailing List) wrote: >> >>> Jun 06 23:23:12 cliffhanger systemd[3337]: Failed to copy os- >>> release for >>> propagation, ignoring: No such file or directory >> >> >>> www.linuxfromscratch.org/lfs/view/stable-systemd/chapter11/theend.html >>> That's odd. Were you still in chroot? Did you customize the fields >> 'DISTRIB_CODENAME' and 'VERSION_CODENAME'? >> >> No but it helps if one has the file at all! Installation was >> through jhalfs >> and totally missed it. Installed it now and all okay. > >> Jhalfs has been creating os-release for systemd since 2017 (and for >> sysv since 2020)... If this has not been done, I'd say you may have had > .previous errors (so that the commands for creating it have not been >> run). Note that of course bugs may happen, so you might want to open a >> thread on alfs-discuss. > > I know how this happened. Every time I've built LFS with jhalfs I've let it > build the kernel with everything in place. But It's always failed and that's > where I stop the build. Hence no os-release file. I'll note here that I never have jhalfs build the kernel. My procedure is just too different. My naming of the kernel, config, and System.map is different. I use a custom config. I need firmware that is not installed by jhalfs. I'll also note that I always configure grub by hand. IMO, some things just don't lend themselves to automation. -- Bruce -- http://lists.linuxfromscratch.org/sympa/info/blfs-support Unsubscribe: See the above information page