Re: Re: Re: Problems with Netgear MA111; DWL-122 update

Too bad we couldn't identify the real source of the pre-load  - for all we know FC3 may be clever enough to try and
push things like that into the initrd/initramfs
if you had the card present when you first installed FC3.

If you are on hal 0.4.7, you would need to re-compile it
to stop it reading /proc/bus/usb/devices when you plugged another device in. I gave details in an earlier post.
I'm hoping/expecting that for >=0.5.0 this won't be necessary.

I need to play a bit more myself - and then we could suggest
something goes in the README/FAQ.

Karl

> Anyway, it seems to be working so far, the only misbehaviour I've had
> from the adaptor since has been attributable to me playing around with
> hal and plugging in another USB device.
> 
> I think it would be well worth adding some comments about this to the
> README, as it's an issue that seems likely to bite a large proportion
> of prism2_usb users.
> 


-----------------------------------------
Email provided by http://www.ntlhome.com/