Re: Difficulty getting device to recognize driver

On Sunday 24 July 2005 08:13, 刘华 wrote:
> linux-wlan-user，您好！
>
>  Have you get your WMP11 V4 work? I have the same pain as you.
>
This card does not use the prism chipset.  I have two of these linksys cards, 
one a version 3, and the other a version 4.  The version 3 uses a prism 
chipset, version 4 uses a different chipset (atheros maybe) and is thus not 
supported by the wlan-ng drivers.  


>  "lspci -v" output is:
>  01:07.0 Ethernet controller: Linksys, A Division of Cisco Systems WMP11v4
> 802.11b PCI card Subsystem: Linksys: Unknown device 0020
>  Flags: bus master, medium devsel, latency 64, IRQ 9
>  Memory at fdfff800 (32-bit, non-prefetchable) [size=2K]
>  Capabilities: [40] Power Management version 2
>
>  As you seeing, no I/O Port.
>
>  my software is:
>  linux FC3(2.6.9-1.667)
>  wlan-ng-0.2.1-pre26
>
>  After install the wlan-ng driver, I just add the following lines:
>
>   modprobe prism2_pci prism2_debug=3
>      wlanctl-ng wlan0 lnxreq_ifstate ifstate=enable
>      wlanctl-ng wlan0 lnxreq_autojoin ssid=linksys authtype=opensystem
>      ifconfig wlan0 169.254.8.200 netmask 255.255.0.0 broadcast
> 169.254.255.255 route add default gw 169.254.8.200
>
>   to /etc/rc.d/rc.local
>
> 	and add the alias wlan0 prism2_pci to the /etc/modprobe.conf because I can
> not find the /etc/modules.conf under the Linux 2.6.9-1.667 OS.
>
> 	Did I miss something or make mistakes?
>
> 	Any hint will be appreciated.
>
> 　　　　　　　　致
> 礼！
>
>
> 　　　　　　　　刘华
> 　　　　　　　　[email protected]
> 　　　　　　　　　　2005-07-23
>
> _______________________________________________
> Linux-wlan-user mailing list
> [email protected]
> http://lists.linux-wlan.com/mailman/listinfo/linux-wlan-user

_______________________________________________
Linux-wlan-user mailing list
[email protected]
http://lists.linux-wlan.com/mailman/listinfo/linux-wlan-user

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.5 (GNU/Linux)

iD8DBQBC5R7qwRXgH3rKGfMRAgMhAJ9H0ef/6YUlDD5YNu201mnLMrJX5ACfU9H3
c4p+KYrGIlYLdhOWtO/2gY4=
=mfTn
-----END PGP SIGNATURE-----