Can not get Linksys WMP11 version 4 work

Hello,linux-wlan-user！
      I had tried a long time to make WMP11 version 4 as a AP using liunx-wlan-ng 0.2.1pre26,
but it seems the driver and the device not match.
	  Following the README instructions, My "lspci -v" output is:
01:07.0 Ethernet controller: Linksys, A Division of Cisco Systems WMP11v4 802.11b PCI card
Subsystem: Linksys: Unknown device 0020
Flags: bus master, medium devsel, latency 64, IRQ 9
Memory at fdfff800 (32-bit, non-prefetchable) [size=2K]
Capabilities: [40] Power Management version 2

	By the way, I failed to find the /etc/modules.conf(or configs.modules), where I put the "alias wlan0 prism2_pci"  and "options p80211 wlan_debug=2" "options  prism2_pci prism2_debug=3"
/etc/modprobe.conf??

My kernel version is 2.6.9-1.667(FC3)

Any one get the card work as a AP?
	

　　　　　　　　致
礼！
 				

　　　　　　　　刘华
　　　　　　　　[email protected]
　　　　　　　　　　2005-07-26