Re: Tertiary firmware load problem for Netgear MA311 AP

My environment is :
FC4-2.6.11 kernel
0.2.2 linux-wlan-ng driver
Dell Optiplex Gx110
 Other useful information:
lspci -vv output:
01:07.0 Network controller: Intersil Corporation Prism 2.5 Wavelan chipset 
(rev 01)
Subsystem: Intersil Corporation Prism 2.5 Wavelan chipset
Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV+ VGASnoop- ParErr- 
Stepping- SERR+ FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- 
<MAbort- >SERR- <PERR-
Interrupt: pin A routed to IRQ 9
Region 0: Memory at fafff000 (32-bit, prefetchable) [size=4K]
Capabilities: [dc] Power Management version 2
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=0 PME-
 cat /proc/pci:
Bus 1, device 7, function 0:
Class 0280: PCI device 1260:3873 (rev 1).
IRQ 9.
Master Capable. Latency=64. 
Prefetchable 32 bit memory at 0xfafff000 [0xfaffffff].
 The IRQ 9 is shared with below device:
  Bus 0, device 1, function 0:
Class 0300: PCI device 8086:7125 (rev 3).
IRQ 9.
Prefetchable 32 bit memory at 0xf4000000 [0xf7ffffff].
Non-prefetchable 32 bit memory at 0xff000000 [0xff07ffff].
 I searched all maillist for MA311, but all I got is using the card as a 
terminal.
Did anyone successfully make the card as a AP?
 It's urgent to make a conclusion.
Really appreciate any help.

_______________________________________________
Linux-wlan-devel mailing list
[email protected]
http://lists.linux-wlan.com/mailman/listinfo/linux-wlan-devel