Re: can't connect after kismet

Chris Bare wrote:
> I have wlan-ng-0.2.2 built with kernel 2.6.12. If I run the following:
> 
>  wlanctl-ng wlan0 lnxreq_ifstate ifstate=enable
>  wlanctl-ng wlan0 lnxreq_autojoin ssid="" authtype=opensystem
>  dhcpcd wlan0
> 
> I get connected to my AP, no problem.
> 
> If I then run Kismet, it works fine, and when I exit I get this message:
> 
> WARNING: wlan0 (wlan0) unable to exit monitor mode automatically.  You may
>          need to manually restart the device and reconfigure it for normal
>          operation.Kismet exiting.
> 
> I've tried various combinations of wlanctl-ng commands, but can't seem to find
> the magic to "manually restart the device".
> 
> Does anyone know the right command(s)?
I think it used to say "manually disconnect" before.