ifconfig doesn't show RUNNING

Hi. I am trying to get a prism2 PCMCIA card running under Fedora 2.6.14_FC4 
with the 0.2.3 driver. The driver installs, recognizes the card, etc. When I 
try ifconfig, the information returned does not show RUNNING.

wlan0     Link encap:Ethernet  HWaddr 00:02:68:00:00:9B
          inet addr:192.168.0.2  Bcast:192.168.0.255  Mask:255.255.255.0
          inet6 addr: fe80::202:68ff:fe00:9b/64 Scope:Link
          UP BROADCAST MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
          Interrupt:3 Base address:0x2100

I'm not sure if it's related, but I can not ping the card. It doesn't appear 
to be receiving packets.  Any ideas or suggestions are greatly appreciated.

Thanks,
marcos