Re: ifconfig doesn't show RUNNING

When you say you cannot ping the card, do you mean you cannot ping it
from a remote machine or you cannot ping the card from the machine
itself? If its the former, it's more likely a firewall issue as from the
output of ifconfig it all looks good.

Regards
David

Marcos Hacker wrote:
> Hi. I am trying to get a prism2 PCMCIA card running under Fedora 2.6.14_FC4 
> with the 0.2.3 driver. The driver installs, recognizes the card, etc. When I 
> try ifconfig, the information returned does not show RUNNING.
>
> wlan0     Link encap:Ethernet  HWaddr 00:02:68:00:00:9B
>           inet addr:192.168.0.2  Bcast:192.168.0.255  Mask:255.255.255.0
>           inet6 addr: fe80::202:68ff:fe00:9b/64 Scope:Link
>           UP BROADCAST MULTICAST  MTU:1500  Metric:1
>           RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:1000
>           RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
>           Interrupt:3 Base address:0x2100
>
> I'm not sure if it's related, but I can not ping the card. It doesn't appear 
> to be receiving packets.  Any ideas or suggestions are greatly appreciated.
>
> Thanks,
> marcos
>
>
> _______________________________________________
> Linux-wlan-user mailing list
> [email protected]
> http://lists.linux-wlan.com/mailman/listinfo/linux-wlan-user
>