Re: Bonding+vlan and initscripts problem

Buchan Milne a =E9crit :

> I would try adding:
> IPADDR=3D0.0.0.0
> here (to bond0), maybe also with:
> NETMASK=3D0.0.0.0
>=20
I remember trying this IPADDR=3D0.0.0.0
not netmask but

As I have write
I have made some test with Static IP dirtectly on bond device
and this is the same problem eth0 and eth1 aren't enslaved at boot time

In this case ifcfg-bond0 was :
DEVICE=3Dbond0
BOOTPROTO=3Dstatic
IPADDR=3D192.168.254.200
NETMASK=3D255.255.255.0
BROADCAST=3D192.168.254.255
MII_NOT_SUPPORTED=3Dyes
ONBOOT=3Dyes
USERCTL=3DNO


>> ifcfg-bond0.999:
>> DEVICE=3Dbond0.999
>> BOOTPROTO=3Dstatic
>> ONBOOT=3Dyes
>> IPADDR=3D192.168.254.200
>> NETMASK=3D255.255.255.0
>> BROADCAST=3D192.168.254.255
>> USERCTL=3Dno
>> MII_NOT_SUPPORTED=3Dyes
>>
>> I also tried with an IP address directly on the bond device ( No VLAN =
)
>> symptoms are the same eth0 and eth1 are NOT enslaved at boot time
>=20
> Can you provide the contents of /etc/modprobe.conf? Since, we also (at =
least=20
> on RHEL, I don't have any Mandriva boxes running with bond+VLAN at pres=
ent)=20
> add:
> alias bond0 bonding

Of course I Have This

alias bond0 bonding
options bonding miimon=3D100 mode=3D4

Regards
--=20
  Weill Philippe -  Administrateur Systeme et Reseaux