Re: Bonding+vlan and initscripts problem

On Fri, Jan 20, 2006 at 01:44:52PM +0100, Philippe Weill wrote:
>I have somes problems activating bond driver on a mandriva 2006
>I know it's not cooker but it's server related
....
>I also tried with an IP address directly on the bond device ( No VLAN )
>symptoms are the same eth0 and eth1 are NOT enslaved at boot time
>
i use these settings

==> /etc/sysconfig/network-scripts/ifcfg-bond0 <==
DEVICE=bond0
TYPE=Bonding
BOOTPROTO=none
IPADDR=192.168.0.1
NETMASK=255.255.255.0
ONBOOT=yes

==> /etc/sysconfig/network-scripts/ifcfg-eth0 <==
DEVICE=eth0
MASTER=bond0
SLAVE=yes
ONBOOT=yes

==> /etc/sysconfig/network-scripts/ifcfg-eth1 <==
DEVICE=eth1
MASTER=bond0
SLAVE=yes
ONBOOT=yes

i also have
==> /etc/modprobe.conf <==
alias bond0 bonding
options bonding miimon=100 mode=6

you should chose "mode" according to your requirements, the "miimon" is
important or failover will not work.

Regards,
L.


-- 
Luca Berra -- [email protected]
        Communication Media & Services S.r.l.
 /"\
 \ /     ASCII RIBBON CAMPAIGN
  X        AGAINST HTML MAIL
 / \