Re: 2 bridges on a single PC!!

 
> I would like to know how can we distinguish between ebtables rules
that belong to each bridge device? 

Surely that would be by the ethernet port they enter from?

> Also how is tha forwarding between these bridge devices done?

It isn't. Otherwise, why do you have two separate bridges?




-----Original Message-----
From: ebtables-user-bounces-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f@public.gmane.org
[mailto:ebtables-user-bounces-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f@public.gmane.org] On Behalf Of
Ramsurrun Visham
Sent: Monday, 17 December 2007 9:41 PM
To: [email protected]
Subject: [Ebtables-user] 2 bridges on a single PC!!

Hi to all,

I have created 2 bridges on a single PC. I would like to know how can
we distinguish between ebtables rules that belong to each bridge
device? Also how is tha forwarding between these bridge devices done?

Thx in advance..

Warm regards,
Visham

------------------------------------------------------------------------
-
SF.Net email is sponsored by:
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services
for just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketp
lace
_______________________________________________
Ebtables-user mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/ebtables-user

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/