Re: 1 Router, 2 Uplinks, 1 Netflow
Simone Mainardi <[email protected]>
| Newsgroups | gmane.linux.ntop.general |
|---|---|
| Message-ID | <[email protected]> |
Matthias, You can either enable the dynamic interfaces creation on the ntopng side (e.g., on the basis of the %EXPORTER_IPV4_ADDRESS) or you can run two separate nprobes, one per stream, and then send the results to two ntopng interfaces. Regard, Simone > On 10 Dec 2017, at 15:39, Matthias Henze <[email protected]> wrote: > > Hi, > > currently I use 2 routers for my 2 uplinks. Now I've a new router witch is able to handle 2 uplinks. The new router sends one NetFlow stream. I can configure it to send NetFlow data for both uplinks. How to configure Nprobe and Ntop to get two interfaces in Ntop? > > TIA > Matthias > > > -- > > MHC SoftWare GmbH > Fichtera 17 > 96274 Itzgrund/Germany > voice: +49-(0)9533-92006-0 > fax: +49-(0)9533-92006-6 > e-mail: [email protected] > > HR Coburg: B2242 > Geschaeftsfuehrer: Matthias Henze > > > > _______________________________________________ > Ntop mailing list > [email protected] > http://listgateway.unipi.it/mailman/listinfo/ntop