lock ups with 2.6

on boot, w/o card in(locks up if card is in)

Linux Kernel Card Services

  options:  [pci] [cardbus] [pm]

Yenta: CardBus bridge found at 0000:00:0a.0 [103c:0024]

Yenta: ISA IRQ list 04b8, PCI irq11

Socket status: 30000417

cs: IO port probe 0xff40-0xff7f: clean.

lp0: using parport0 (polling).

NET: Registered protocol family 10

IPv6 over IPv4 tunneling driver

hdc: ATAPI 24X DVD-ROM CD-R/RW drive, 2048kB Cache, DMA

Uniform CD-ROM driver Revision: 3.12

mtrr: 0xe0000000,0x4000000 overlaps existing 0xe0000000,0x1000000



----

if i don't have card in, then start it after boot(works fine then)

or if i rmmod all the modules after letting it run on boot, and put back in the wpc11, it works fine, and this is what i get



unloading Kernel Card Services

Linux Kernel Card Services

  options:  [pci] [cardbus] [pm]

Yenta: CardBus bridge found at 0000:00:0a.0 [103c:0024]

Yenta: ISA IRQ list 0498, PCI irq11

Socket status: 30000411

cs: IO port probe 0xff40-0xff7f: clean.

cs: memory probe 0xffeff000-0xffefffff: clean.

orinoco.c 0.13e (David Gibson <[email protected]> and others)

orinoco_cs.c 0.13e (David Gibson <[email protected]> and others)

eth1: Station identity 001f:0000:0000:0008

eth1: Looks like an Intersil firmware version 0.8.0

eth1: Ad-hoc demo mode supported

eth1: IEEE standard IBSS ad-hoc mode supported

eth1: WEP supported, 104-bit key

eth1: MAC address 00:04:5A:CE:7E:29

eth1: Station name "Prism  I"

eth1: ready

eth1: index 0x01: Vcc 5.0, irq 7, io 0xff40-0xff7f

eth1: Error -110 setting multicast list.

eth1: Error -110 setting multicast list.

eth1: Error -110 setting multicast list.

eth1: New link status: Connected (0001)





_______________________________________________
No banners. No pop-ups. No kidding.
Introducing My Way - http://www.myway.com


-------------------------------------------------------
This SF.net email is sponsored by: SF.net Giveback Program.
Does SourceForge.net help you be more productive?  Does it
help you create better code?  SHARE THE LOVE, and help us help
YOU!  Click Here: http://sourceforge.net/donate/