Controlling HD44780 LCD via I2C-GPIO-Expander?
Conrad Braun <[email protected]>
| Newsgroups | gmane.linux.ports.arm.general |
|---|---|
| Message-ID | <[email protected]> |
Hello, I'm currently trying to control an LCD via a PCF8574 I2C GPIO expander. It looks as if I'm running into timing problems on an AT91RM9200 conitec board with the I2C_GPIO driver and kernel 2.6.28; there is a delay of almost 8ms between every byte sent over the I2C bus. Is this possibly an effect of using the I2C_GPIO driver, or am I looking at the wrong suspect? I haven't found any hints on this matter in the mailing list archives or the web, though, so maybe there's another problem. I'm out of clues, tbh, and any help is appreciated. Thanks, Conrad ------------------------------------------------------------------- List admin: http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm FAQ: http://www.arm.linux.org.uk/mailinglists/faq.php Etiquette: http://www.arm.linux.org.uk/mailinglists/etiquette.php