Re: Controlling HD44780 LCD via I2C-GPIO-Expander?

On Tuesday 16 June 2009, Conrad Braun wrote:
> Hello,
>
> I'm currently trying to control an LCD via a PCF8574 I2C GPIO expander.
> It looks as if I'm running into timing problems on an AT91RM9200 conitec
> board with the I2C_GPIO driver and kernel 2.6.28; there is a delay of
> almost 8ms between every byte sent over the I2C bus. Is this possibly an
> effect of using the I2C_GPIO driver, or am I looking at the wrong suspect?
> I haven't found any hints on this matter in the mailing list archives or
> the web, though, so maybe there's another problem. I'm out of clues, tbh,
> and any help is appreciated.
>
> Thanks,
>  Conrad

The I2C_GPIO driver in itself is probably not to blame, although using a 
hardware I2C uart will be faster.  What is the clock frequency you've 
selected?  What kind of messaging are you using?  For the best performance 
trying to send multi-byte messages it's probably best to use the low level 
I2C interface by formatting the message into a buffer then sending it out 
using the 'ioctl(<i2c_device>,I2C_RDWR,&buffer);'

-Jeff
-- 
Secure your email with Gnu Privacy Guard and Thunderbird, the open source
cross platform solution for Windows, Linux, and Mac OS X.
See http://enigmail.mozdev.org/

-------------------------------------------------------------------
List admin: http://lists.arm.linux.org.uk/mailman/listinfo/linux-arm
FAQ:        http://www.arm.linux.org.uk/mailinglists/faq.php
Etiquette:  http://www.arm.linux.org.uk/mailinglists/etiquette.php