Re: arm gpio setting
Subramani Venkatesh <[email protected]>
| Newsgroups | gmane.linux.ports.arm.general |
|---|---|
| Message-ID | <[email protected]> |
This email is so noisy, you have been sending it repeatedly .. On Thu, May 13, 2010 at 5:42 AM, sneha prakash <[email protected]> wrote: > Hi , > We are using i.mx 25 board which consists of arm9 controller.I > need to > convert the CMOS connector in the board to parallel port pins.We > have to > convert CMOS connector pins to GPIO pins using IOMUX > configuration.Could > any one help me to configure GPIO pins as parallel port pins and to > set > the base address. > Regards, > sneha. > > > _______________________________________________ > linux-arm mailing list > [email protected] > http://lists.infradead.org/mailman/listinfo/linux-arm > > _______________________________________________ linux-arm mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm