Re: gpio setting

what is kernel version?
regars .
s.doron.

2010/5/14 sneha prakash <[email protected]>

>
>
> ---------- Forwarded message ----------
> From: sneha prakash <[email protected]>
> Date: Thu, May 13, 2010 at 3:12 PM
> Subject: arm gpio setting
> To: [email protected]
>
>
> Hi ,
>         We are using i.mx 25 board which consists of arm9 controller.I
> need to
>         convert the CMOS connector in the board to parallel port pins.We
> have to
>         convert CMOS connector pins to GPIO pins using IOMUX
> configuration.Could
>         any one help me to configure GPIO pins as parallel port pins and to
> set
>         the base address.
> Regards,
>       sneha.
>
>
>
> _______________________________________________
> linux-arm mailing list
> [email protected]
> http://lists.infradead.org/mailman/listinfo/linux-arm
>
>


-- 
doron sandroy
[email protected]
052-6070406

_______________________________________________
linux-arm mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm