Re: [PATCH 2/4] vgacon: rework screen_info #ifdef checks

Arnd Bergmann <[email protected]> writes:

> From: Arnd Bergmann <[email protected]>
>
> On non-x86 architectures, the screen_info variable is generally only
> used for the VGA console where supported, and in some cases the EFI
> framebuffer or vga16fb.
>
> Now that we have a definite list of which architectures actually use it
> for what, use consistent #ifdef checks so the global variable is only
> defined when it is actually used on those architectures.
>
> On powerpc, there is no support for vgacon, but there is support for
> vga16fb. Loongarch and riscv have no support for vgacon or vga16fb, but
> they support EFI firmware, so only that needs to be checked, and the
> initialization can be removed because that is handled by EFI.
> IA64 has both vgacon and EFI.
>
> Signed-off-by: Arnd Bergmann <[email protected]>
> ---

[...]

> diff --git a/arch/ia64/kernel/setup.c b/arch/ia64/kernel/setup.c
> index 5a55ac82c13a4..0c09ff7fde46b 100644
> --- a/arch/ia64/kernel/setup.c
> +++ b/arch/ia64/kernel/setup.c
> @@ -86,9 +86,11 @@ EXPORT_SYMBOL(local_per_cpu_offset);
>  #endif
>  unsigned long ia64_cycles_per_usec;
>  struct ia64_boot_param *ia64_boot_param;
> +#if defined(CONFIG_VGA_CONSOLE) || defined(CONFIG_EFI)
>  struct screen_info screen_info;

I think that only screen_info should be guarded by both symbols ?

>  unsigned long vga_console_iobase;

It seems this variable was never used since it was introduced by commit
66b7f8a30437 ("[IA64-SGI] pcdp: add PCDP pci interface support") ?

>  unsigned long vga_console_membase;

And this is only used by mdacon (not supported by ia64), vgacon and
vga16fb (not supported by ia64 either).

So this could just be guarded just by CONFIG_VGA_CONSOLE for ia64 ?

The rest of the patch looks good to me.

Reviewed-by: Javier Martinez Canillas <[email protected]>

-- 
Best regards,

Javier Martinez Canillas
Core Platforms
Red Hat