[PATCH 1/2] sh: align .bss section padding to 8-byte boundary

J2 based devices expect to find a devicetree blob at the end of the bss
section. As of a77725a9a3c5, libfdt enforces 8-byte alignment for the
dtb, causing J2 devices to fail early in sh_fdt_init.

As J2 loader firmware calculates the dtb location based on the kernel
image .bss section size, rather than the __bss_stop symbol offset, the
required alignment can't be enforced with BSS_SECTION(0, PAGE_SIZE, 8).
Instead, inline modified version of the above macro, which grows .bss
by the required size.

While this change affects all existing SH boards, it should be benign on
platforms which don't need this alignment.

Signed-off-by: Artur Rojek <[email protected]>
---
 arch/sh/kernel/vmlinux.lds.S | 15 ++++++++++++++-
 1 file changed, 14 insertions(+), 1 deletion(-)

diff --git a/arch/sh/kernel/vmlinux.lds.S b/arch/sh/kernel/vmlinux.lds.S
index 9644fe187a3f..008c30289eaa 100644
--- a/arch/sh/kernel/vmlinux.lds.S
+++ b/arch/sh/kernel/vmlinux.lds.S
@@ -71,7 +71,20 @@ SECTIONS
 
 	. = ALIGN(PAGE_SIZE);
 	__init_end = .;
-	BSS_SECTION(0, PAGE_SIZE, 4)
+	__bss_start = .;
+	SBSS(0)
+	. = ALIGN(PAGE_SIZE);
+	.bss : AT(ADDR(.bss) - LOAD_OFFSET) {
+		BSS_FIRST_SECTIONS
+		. = ALIGN(PAGE_SIZE);
+		*(.bss..page_aligned)
+		. = ALIGN(PAGE_SIZE);
+		*(.dynbss)
+		*(BSS_MAIN)
+		*(COMMON)
+		. = ALIGN(8);
+	}
+	__bss_stop = .;
 	_end = . ;
 
 	STABS_DEBUG
-- 
2.48.1