Re: Epson EcoTank Support
Alvaro Kuolas <[email protected]>
| Newsgroups | gmane.linux.printing.gimp-print.devel |
|---|---|
| Message-ID | <CAKUwrzDKxdJQDzPGa=N=Zo78226i8gE0uGDdkj=sdhTuuDBE_A@mail.gmail.com> |
If I want to bring support for my L375: Where do I start? Could you give me a heads up? I am willing to read, learn, research whatever you throw to my hands. I've tried using the L375 telling my system that the printer is a L310 but I got blinking light but no actual printing. That's as far as I got, and believed that ESC/P-R was the culprit. Thanks for your time! On Fri, Feb 19, 2021 at 10:17 AM Robert Krawitz <[email protected]> wrote: > On 2/18/21 8:01 PM, Alvaro Kuolas wrote: > > I have a L375, It does have the same printhead as L310, but L375 and > modern EPSON L-Series uses > > ESC/P-R instead of ESC/P2. > > > > I believe that is why it is not supported by Gutenprint. Right? > > Many if not all printers (at least those based on 360 DPI vs. 300 DPI) > that support ESCP/R also > support ESC/P2. So it's worth a try. > > > On Thu, Feb 18, 2021 at 9:08 PM Robert Krawitz <[email protected] > <mailto:[email protected]>> wrote: > > > > On 2/18/21 10:52 AM, John Downie via Gimp-print-devel wrote: > > > Hello, > > > > > > I am looking into investing in a RIP, etc., to use an EcoTank > printer for monochrome using carbon > > > inksets. > > > > > > All of the EcoTank printers on the 5.3.3 list have been replaced, > many with similar model numbers. > > > > > > I am willing to take some risks here, but wondered if how > model-dependent the support is, i.e., is > > > there a reasonable chance support for the 2700 and/or 2750 would > work for the current 2720 or > > 2760? > > > > > > I understand that you probably cannot be definitive in your > answers. > > > > Historically -- and I haven't checked the specs -- there isn't a lot > of functional change between > > printer engines; it's usually ancillary features that are changed, > or even just refreshed. But > > Epson doesn't publish detailed specs as much, so short of buying one > it might be hard for me to > > determine. > > > > _______________________________________________ > Gimp-print-devel mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/gimp-print-devel > _______________________________________________ Gimp-print-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/gimp-print-devel