Re: Can omit user and password

Please use the mailing list [email protected].
I've never issued username and password and worked fine for me.
Check you W2K[3] setup.

On Mon, Mar 22, 2004 at 07:40:09AM -0300, Rodrigo Barros wrote:
> I'm using pxes-config to build my own images but if i leave the fields
> user and password blank for terminal service options, after booting the
> client I receive a message saying that the connection was reseted by
> peer, If i Fill out all the information I have no problem.
> Just one more question, is there any link where I can find some
> information about remote configuration?? I've been trying to use it but
> with no success.
> 
> Thanks,
> 
> 
> Rodrigo
> 
> 
> -------------------------------------------------------
> This SF.Net email is sponsored by: IBM Linux Tutorials
> Free Linux tutorial presented by Daniel Robbins, President and CEO of
> GenToo technologies. Learn everything from fundamentals to system
> administration.http://ads.osdn.com/?ad_id70&alloc_id638&opick
> _______________________________________________
> pxes-devel mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/pxes-devel

-- 
    ______  ________                                             
   /  /   \/  /___  )  I  N   T   E   G   R   A   C   I   O   N  
  /  /       /___  /   I  N   F   O   R   M   A   T   I   C   A  
 /__/__/\___/_____'    

 Diego Torres Milano   42 Maipu Of. 164  -  (1084) Buenos Aires
 <[email protected]>    Argentina. Tel: +5411 4331-2233 Fax 4331-3377


-------------------------------------------------------
This SF.Net email is sponsored by: IBM Linux Tutorials
Free Linux tutorial presented by Daniel Robbins, President and CEO of
GenToo technologies. Learn everything from fundamentals to system
administration.http://ads.osdn.com/?ad_id70&alloc_id638&op=click