centos bond interface

Julie Xu <[email protected]>
Newsgroups gmane.linux.redhat.general
Message-ID <[email protected]> 

Hi
I have  HP blades with centos O/S, I have bond 4 interface together and pluged into cisco switch,  one of them has problem which some interfaces can not go online when we change cisco switch module.
if it is any problem which server's bonding will cause?
my bond configuration is:DEVICE=bond0BOOTPROTO=noneONBOOT=yesNETWORK=xxxxxNETMASK=xxxIPADDR=xxxxUSERCTL=noGATEWAY=1xxxxTYPE=BONDIPV6INIT=noIPV6ADDR=IPV6_DEFAULTGW=
interface is:DEVICE=eth0HWADDR=xxxxxONBOOT=yesBOOTPROTO=noneMASTER=bond0SLAVE=yesUSERCTL=noTYPE=Ethernet
on swithes there is normal port (no teamed or channeled)
Could anyone advice me that if anything I need reset on server sidt?
Any comments will be appreciated
thanks in advance
xll

 		 	   		  
-- 
redhat-list mailing list
unsubscribe mailto:[email protected]?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/redhat-list
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.