Re: centos bond interface
Corey Kovacs <[email protected]>
| Newsgroups | gmane.linux.redhat.general |
|---|---|
| Message-ID | <CAMH2m-pH-n_waQaLvY7aes=JR1Awq6uWHqqQDGwfmkRZA+qRig@mail.gmail.com> |
Have you loaded the "bonding" driver by placing the following in your /etc/modprobe.conf? alias bond0** bonding Also, you need to set the bonding mode which can be done in either the modprobe.conf file or the ifcfg-bond0 file as in ... https://access.redhat.com/knowledge/docs/en-US/Red_Hat_Enterprise_Linux/6/html/Deployment_Guide/s2-networkscripts-interfaces-chan.html On Sun, Dec 2, 2012 at 6:43 PM, Julie Xu <[email protected]> wrote: > > DEVICE=bond0BOOTPROTO=noneONBOOT=yesNETWORK=xxxxxNETMASK=xxxIPADDR=xxxxUSERCTL=noGATEWAY=1xxxxTYPE=BONDIPV6INIT=noIPV6ADDR=IPV6_DEFAULTGW= > interface > is:DEVICE=eth0HWADDR=xxxxxONBOOT=yesBOOTPROTO=noneMASTER=bond0SLAVE=yesUSERCTL=noTYPE=Ethernet > -- redhat-list mailing list unsubscribe mailto:[email protected]?subject=unsubscribe https://www.redhat.com/mailman/listinfo/redhat-list