Router failover

[email protected]
Newsgroups gmane.linux.redhat.piranha
Message-ID <[email protected]> 
Hello!
I'm using piranha for setting up LVS-NAT cluster. I've noticed that
after active router fails, backup router becomes active but if
former active router starts working again, they're using the same ip
addresses, i.e. backup router doesn't notice that active recovered
from failure. Is it supposed to work this way? I also want to run some
scripts when router failover occurs. Is it possible?
Thanks in advance,
       Eugene

-- 
Email: <jmv at online.ru>
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.