Re: Config Piranha

On Thu, 2006-01-26 at 13:37 +0100, José María Lopez Marzal wrote:
> Hi,
> 
>  
> 
> Well, I’m novel with piranha but I need configure a load balance
> system in two servers with Piranha. I have installed the software and
> is running ok. The problem is that now I must configure it in two
> servers and I don’t know very good how doing it.
> 
>  
> 
> Somebody could help me with this problem.
> 
>  
> 
> Thanks to all.

The official manual from Red Hat would be good enough:
http://www.redhat.com/docs/manuals/csgfs/browse/rh-cs-en/pt-lvs.html

State your problem precisely for people may help you. Please don't
forget to mention your RHEL version, kernel version, piranha version
etc.

-- 
Regards,
+--------------------------------+
|       Mohd Irwan Jamaluddin    |
| ##    System Engineer,         |
| (o_   Magnifix Sdn. Bhd.       |
| //\   Tel: +603 42705073       |
| V_/_  Fax: +603 42701960       |
|       http://www.magnifix.com/ |      
+--------------------------------+