Config Piranha

Hi,

 

Thanks for your answer,

 

Well, My principal problem is that I never configure the software Piranha and I don't know how I have to doing. Like system operator I use Red Hat AS 3.0 with the kernel the it have for default. The version of Piranha is the last one.

 

I hope so somebody can to help me,

 

Thanks to all.

 

Chema.

 

> Hi,

> 

>  

> 

> Well, I'm novel with piranha but I need configure a load balance 

> system in two servers with Piranha. I have installed the software and 

> is running ok. The problem is that now I must configure it in two 

> servers and I don't know very good how doing it.

> 

>  

> 

> Somebody could help me with this problem.

> 

>  

> 

> Thanks to all.

 

The official manual from Red Hat would be good enough:

http://www.redhat.com/docs/manuals/csgfs/browse/rh-cs-en/pt-lvs.html <http://www.redhat.com/docs/manuals/csgfs/browse/rh-cs-en/pt-lvs.html> 

 

State your problem precisely for people may help you. Please don't forget to mention your RHEL version, kernel version, piranha version etc.

 

--

Regards,

+--------------------------------+

|       Mohd Irwan Jamaluddin    |

| ##    System Engineer,         |

| (o_   Magnifix Sdn. Bhd.       |

| //\   Tel: +603 42705073       |

| V_/_  Fax: +603 42701960       |

|       http://www.magnifix.com/ <http://www.magnifix.com/>  |      

+--------------------------------+

 

_______________________________________________

Piranha-list mailing list

[email protected]

https://www.redhat.com/mailman/listinfo/piranha-list <https://www.redhat.com/mailman/listinfo/piranha-list>

_______________________________________________
Piranha-list mailing list
[email protected]
https://www.redhat.com/mailman/listinfo/piranha-list