Dell PowerEdge 4600 / Broadcomm NIC (bcm5700) Duplex settings

Hi

I'm a bit of a newbie, and I'm having problems setting the line speed
and duplex settings on a Dell PowerEdge 4600 with an onboard Broadcomm
1Gbps NIC. The NIC is set to autonegotiate, bit I want to force it to
100Mb Full Duplex, and I'm not sure how.

I have tried passing some parameters in modules.conf, and mii-tool
doesn't work with this nic.

The system is Red Hat Advanced Server 2.1 with all current updates.

Any help would be greatly appreciated.

Thanks

James Butler


***************************************************************************
Messages included in this e-mail and any of its attachments are those
of the author unless specifically stated to represent WorkCover Queensland.
The contents of this message are to be used for the intended purpose only
and are to be kept confidential at all times. This message may contain
privileged information directed only to the intended addressee/s.
Accidental receipt of this information should be deleted promptly
and the sender notified.
This e-mail has been scanned by Sophos for known viruses.
However, no warranty nor liability is implied in this respect.
**********************************************************************