Re: cdrw driver for HP8200e

fred smith <[email protected]> Sat, 19 Jul 2003 06:47:37 -0400
Newsgroups gmane.linux.redhat.release.enigma
Message-ID <[email protected]>
On Fri, Jul 18, 2003 at 10:39:57PM -0500, DT Wilterding wrote:
> Blind alleys, mazes, and bum steers...  That's all I've seen when searching 
> (googling mostly, the RH site too) for a driver for this cd burner.  Would 
> someone please be so kind as to point me at a driver for this HP8200e?

Most CD drives don't require any special drivers,... are you sure yours
does?

for CD burning (CDR, CDRW) again the same applies, mostly. If it's a 
SCSI drive you should be able to just plug it in and run the burning
tool of your choice. There's Xcdroast, GnomeToaster, and probably
a dozen more. If it's an ATAPI drive, you'll need to set up your
system to use "scsi emulation" for that drive. If you're booting with
GRUB, just add: "hdc=ide-scsi" to the end of the appropriate "kernel"
entry in /etc/grub.conf, and reboot. You should be all set then.

Fred

-- 
-------------------------------------------------------------------------------
 .----    Fred Smith    /              
( /__  ,__.   __   __ /  __   : /     
 /    /  /   /__) /  /  /__) .+'           Home: [email protected] 
/    /  (__ (___ (__(_ (___ / :__                                 781-438-5471 
-------------------------------- Jude 1:24,25 ---------------------------------