Re: cdrw driver for HP8200e
DT Wilterding <[email protected]> Sat, 19 Jul 2003 06:37:02 -0500
| Newsgroups | gmane.linux.redhat.release.enigma |
|---|---|
| Organization | DTW Tech |
| Message-ID | <[email protected]> |
On Saturday 19 July 2003 05:47 am, fred smith wrote: > On Fri, Jul 18, 2003 at 10:39:57PM -0500, DT Wilterding wrote: > > Blind alleys, mazes, and bum steers... That's all I've seen when > > searching (googling mostly, the RH site too) for a driver for this cd > > burner. Would someone please be so kind as to point me at a driver for > > this HP8200e? > > Most CD drives don't require any special drivers,... are you sure yours > does? No Sir, not sure at all... > > for CD burning (CDR, CDRW) again the same applies, mostly. If it's a > SCSI drive you should be able to just plug it in and run the burning > tool of your choice. There's Xcdroast, GnomeToaster, and probably > a dozen more. If it's an ATAPI drive, you'll need to set up your > system to use "scsi emulation" for that drive. If you're booting with > GRUB, just add: "hdc=ide-scsi" to the end of the appropriate "kernel" > entry in /etc/grub.conf, and reboot. You should be all set then. > > Fred Thanks for the directions; that should ease the frustration factor. Dan Wilterding [email protected] I don't care what "they" say -- ignorance is hell.