RE: synchronizing failed
"Hattie Rouge" <[email protected]>
| Newsgroups | gmane.linux.redhat.release.psyche |
|---|---|
| Message-ID | <[email protected]> |
I bet you don't have an IP address 127.127.1.0 available on your net and the failure is because it couldn't connect. If all you are trying to do is keep your local LAN in sync, you can pick one machine and use rdate in cron to sync the rest to it. If you really need to have accurate time, you're going to have to have an outside clock available somewhere to which to tie your primary machine clock. Dana Bourgeois -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of nauman ahmed Sent: Thursday, July 03, 2003 1:40 PM To: [email protected] Subject: synchronizing failed i wanted to configure an isolated time server for my lan so i added the following lines to etc/ntp.conf file server 127.127.1.0 fudge 127.127.1.0 stratum 10 i commented all other lines except drift file line then i started the ntpd by /etc/init.d/ntpd start it gives the following message synchronizing with time server [FAILED] even during the boot process it is giving the same message .what could be wrong? Do you Yahoo!? SBC Yahoo! DSL - Now only $29.95 per month! -- Psyche-list mailing list [email protected] https://www.redhat.com/mailman/listinfo/psyche-list