Re: Tape Backup device not found error when using mt

[email protected] wrote:

>>Is this a new scsi card? Have you checked for proper termination of the
>>scsi bus? When you installed the DLT, did kudzu recognize it and ask you
>>if you wanted to configure it?
>>    
>>
>
>I got...
>
>st                     31628   0  (autoclean) (unused)
>scsi_mod              107576   3  [st aacraid sd_mod]
>
>Yes it's a new card, just installed today, it's an Adaptec 39160 Ultra 160
>SCSI controller.  Yes kudzu did recognize it and I could config but just let
>it default.  Actually I don't think it's configurable because the manual
>said it's auto config with a preset scsi ID of 7.
>
This could be a problem. Do a  'grep -i aic  /var//log/messages'  and 
check the scsi id of the 39160. If it's set to 7, and the DLT is set to 
7, you will have problems.

Try a:

    cat /proc/scsi/scsi

This should tell you what devices are attached, and give their scsi 
id's. If your DLT is the first tape drive on the system, it should be st0.



-- 
Psyche-list mailing list
[email protected]
https://www.redhat.com/mailman/listinfo/psyche-list