RE: Problem - After a reboot, the *first* `mount -a -t nfs' gets stuck in `D'

Keith Lewis <keithl-t1tvXobVCYWi/[email protected]>
Newsgroups gmane.linux.redhat.release.taroon.general
Message-ID <[email protected]>
RE:
> Have you troubleshot the basics?

	Yep.  First things I checked.

> netstat -in
> Verify error count is 0.

client 1
# netstat -in
Kernel Interface table
Iface       MTU Met    RX-OK RX-ERR RX-DRP RX-OVR    TX-OK TX-ERR TX-DRP TX-OVR Flg
eth0       1500   0  3343820      0      0      0  3078040      0      0      0 BMRU
lo        16436   0     8930      0      0      0     8930      0      0      0 LRU
#

client 2
# netstat -in
Kernel Interface table
Iface       MTU Met    RX-OK RX-ERR RX-DRP RX-OVR    TX-OK TX-ERR TX-DRP TX-OVR Flg
eth0       1500   0   657413      0      0      0  1067736      0      0      0 BMRU
lo        16436   0    55138      0      0      0    55138      0      0      0 LRU
#

nfs server 1 (been up for months)
# netstat -in
Kernel Interface table
Iface       MTU Met    RX-OK RX-ERR RX-DRP RX-OVR    TX-OK TX-ERR TX-DRP TX-OVR Flg
eth0       1500   0 3001317645      0      0      0 3616224851      0      0      0 BMRU
lo        16436   0 1015411515      0      0      0 1015411515      0      0      0 LRU
# 

nfs server 2 
$ netstat -in
Kernel Interface table
Iface       MTU Met    RX-OK RX-ERR RX-DRP RX-OVR    TX-OK TX-ERR TX-DRP TX-OVR Flg
eth0       1500   0 600381384      0      0      0 601422342      0      0      0 BMRU
lo        16436   0 366832146      0      0      0 366832146      0      0      0 LRU


> ethtool <int>

	all are autonegotiated to 1000 full.  

> Verify speed and duplex on the NIC and switch side are the same.

	Good point.  I checked the node end.  Our NIS people are very good.  They
would tell me if the switches were getting errors - esp since I pestered them.

	I've also done things like `ping -s <various sizes> server' from the 
client and leftit running during the failed and working mount attempts.  Didn't 
see anything noteworthy.  Turning off iptables didn't help.  Posting to this 
list has been good tho!

> /Brian/

	btw, we have been running for years with this setup.  Never any problem
even remotely like this in the past.  Then we had the problem two nights in a
row, then last night we didn't.  (The only changes to software on these boxes
are done with up2date -u).

Keith

--
Taroon-list mailing list
[email protected]
https://www.redhat.com/mailman/listinfo/taroon-list
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.