Re: nmap

On Tue, 2004-04-20 at 10:10, Harry Hambi wrote:
>  all,
> From my linux I type the following nmap -sT -vv -O xx.xx.xx.xx-xxx >
> network-scan.txt I want to see whether SSHD, FTP, TELNET, RSH, RLOGIN
> & TFTP are 
> 
>  running on the remote system. If they are running, I want to know
> which port 
>  are they running on.
> I get the following error message no targets were specified,so 0 hosts
> scanned,from the above the xx-xx, notation is a range of ip addresses
> to scan, can you help 

Have you tried a single IP address or a smaller range?

Forrest