Re: RPM constructed name - how to control?

Put in ~/.rpmmacros

%_rpmfilename   %%{NAME}-%%{VERSION}-%%{RELEASE}.%%{ARCH}.rpm

Best Regards

On Thu, May 8, 2008 at 10:25 PM, Tim Mooney <
[email protected]> wrote:

>
> Because your message came through as an attachment it's hard for me to
> quote any of it, but you want to investigate the setting for either
>
>        %_build_name_fmt
>
> or
>
>        rpmfilename
>
> I don't remember which one RPM 3.x used, but I would start with
> %_build_name_fmt.  That's what controls how the file is named with modern
> RPM.
>
> Note, though, that for the example you give, I'm not sure it would be
> advisable to change your %_build_name_fmt, other than to just add
> %%{ARCH} to what's already there.
>
> Tim
> --
> Tim Mooney                              [email protected]
> Information Technology Services         (701) 231-1076 (Voice)
> Room 242-J6, IACC Building              (701) 231-8541 (Fax)
> North Dakota State University, Fargo, ND 58105-5164
>
> _______________________________________________
> Rpm-list mailing list
> [email protected]
> https://www.redhat.com/mailman/listinfo/rpm-list
>

_______________________________________________
Rpm-list mailing list
[email protected]
https://www.redhat.com/mailman/listinfo/rpm-list