Setting up th0

hi

I have a problem during setting up the network
i have to use tr0 and at the configuration i'm asked for the parameters for
this device layer.
Down are the lines from the programm.

Please enter the network device you inted to use (e.g ctc0, escon0, iucv0,
eth0, tr0)
[here i typed tr0]

Please enter any parameters you need to pass to the channel decive layer.
(e.g. "ctc0,0x600,0x601" will activate the ctc interface at I/O ports
0x600,0x6001):
[And here i dont know what to typ]

Can anybody help me?



Mit freundlichen Grüßen

                                         Simon Tischer




IBM Deutschland GmbH
PL Ausbildung Stuttgart 1
KST:3167, Loc 70569-01
Pascalstraße 100, D-70548 Stuttgart
Phone: +49 07031 - 16 4519 (Praxiseinsatz) *120-4519:int.
Phone: +49 0711-785 5443 (Sekretriat ,ext.) *111-5443;int.
E-Mail: [email protected]