ppa zip trouble
Alessandro GARDICH <[email protected]>
| Newsgroups | gmane.linux.redhat.taroon |
|---|---|
| Organization | gremlin.it |
| Message-ID | <[email protected]> |
hi to all ... quite strange to look for an old zip on an ES distro but i don't like it don't run ... i have a zip100 parallel, so using ppa module ... that is the output of dmesg after `modprobe ppa` ppa: Version 2.07 (for Linux 2.4.x) ppa: Found device at ID 6, Attempting to use EPP 32 bit ppa: Found device at ID 6, Attempting to use PS/2 ppa: Communication established with ID 6 using PS/2 scsi0 : Iomega VPI0 (ppa) interface Starting timer : 0 0 Vendor: IOMEGA Model: ZIP 100 Rev: J.03 Type: Direct-Access ANSI SCSI revision: 02 Starting timer : 0 0 Attached scsi removable disk sda at scsi0, channel 0, id 6, lun 0 scsi: device set offline - not ready or command retry failed after bus reset: host 0 channel 0 id 6 lun 0 SCSI device sda: 196608 512-byte hdwr sectors (101 MB) sda: Write Protect is off seem all ok ... but if i try to mount to eject (eject /dev/sda) to list partition table (fdisk -l /dev/sda) i got errors ... sda: I/O error: dev 08:00, sector 0 I/O error: dev 08:00, sector 2 I/O error: dev 08:00, sector 4 I/O error: dev 08:00, sector 6 I/O error: dev 08:00, sector 0 I/O error: dev 08:00, sector 2 I/O error: dev 08:00, sector 4 I/O error: dev 08:00, sector 6 unable to read partition table some more info : *) this happen also on RH9 *) on RH9 seem to work on some prebuild kernels, but never when i recompile, same errors ... thanks ... -- Alessandro GARDICH <[email protected]> gremlin.it -- Taroon-beta-list mailing list [email protected] http://www.redhat.com/mailman/listinfo/taroon-beta-list