Re: Arduino on Mageia linux
Shlomo Solomon <[email protected]>
| Newsgroups | gmane.linux.region.israel |
|---|---|
| Message-ID | <[email protected]> |
Sorry - just noticed I cut off part of the error message, so here it is
again:
WARNING: RXTX Version mismatch
Jar version = RXTX-2.2
native lib Version = RXTX-2.2pre2
Binary sketch size: 1,056 bytes (of a 32,256 byte maximum)
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x00
On Tue, 20 Jun 2017 13:32:28 +0300
Shlomo Solomon <shlomo-JnZJDTviGbbW6+UHpCy/[email protected]> wrote:
> I installed the Arduino IDE from Mageia RPMs and added my user to the
> lock group as instructed.
>
> In the tools >> serial port menu, there is no /dev/ttyUSB0 -
> only /dev/ttyS0 and /dev/ttyS1. I tried both of them but could not
> upload a program. I read that sometimes Arduino needs to be run as
> root, so I tried that too with no success. Here's what I get when I
> try to upload:
>
> Binary sketch size: 1,056 bytes (of a 32,256 byte maximum)
> Binary sketch size: 1,056 bytes (of a 32,256 byte maximum)
> avrdude: stk500_recv(): programmer is not responding
> avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00
> avrdude: stk500_recv(): programmer is not responding
> avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x00
> avrdude: stk500_recv(): programmer is not responding
>
>
>
--
Shlomo Solomon
http://the-solomons.net
Sent by Claws Mail 3.11.1 - KDE 4.14.5 - LINUX Mageia 5
_______________________________________________
Linux-il mailing list
[email protected]
http://mailman.cs.huji.ac.il/mailman/listinfo/linux-il