Re: daz access mask error

I set not in clamd.conf an user.

On two other machines with similar setup its work. 

Am Freitag, den 09.08.2013, 12:08 +0200 schrieb Javier Juan Martínez
Cabezón:
> I'm not at home now to confirm, but I remember that to switch DAZ to
> other user I had to switch the DAZ_ROLE to appropiated one, can you
> send which value has user root in this to see if this is ok?
> 
> 2013/8/9, Jens Kasten <[email protected]>:
> > I set this daz_scanner, but this is left
> >
> >  ERROR: Clamuko: Can't set access mask in Dazuko
> >
> >> > Hi list,
> >> >
> >> > I try to get clamd with dazuko running but I get this error.
> >> >
> >> > Thu Aug  8 21:59:42 2013 : 60004465570|rsbac_adf_request(): request
> >> > READ_WRITE_OPEN, pid 24195, ppid 23171, prog_name clamd, uid 0, remote
> >> > ip 192.168.1.5, target_type DEV, tid char 250:00, attr open_flag, value
> >> > 32770, result NOT_GRANTED (Softmode) by DAZ
> >>
> >> You need to mark clamd as daz_scanner, i.e., set that attribute value to
> >> 1.
> >>
> >> Amon.
> >
> >
> > _______________________________________________
> > rsbac mailing list
> > [email protected]
> > http://www.rsbac.org/mailman/listinfo/rsbac
> >
> _______________________________________________
> rsbac mailing list
> [email protected]
> http://www.rsbac.org/mailman/listinfo/rsbac


_______________________________________________
rsbac mailing list
[email protected]
http://www.rsbac.org/mailman/listinfo/rsbac