[sentinix-list] Sentinix .iso image booting problems

Hi everyone, I've had a look through the archive and have spotted
another user who had a problem booting the .iso image of sentinix but
didn't see a solution. I thought I might raise the question/issue again.
 
I have now downloaded sentinix from three different mirrors each time
the .iso file I've downloaded has come down as exactly the same size and
has the same md5 hash. (MD5 (sentinix-0.70.5.iso) =
15265767531db906ada0a04123051363)
 
However each time I burn the .iso to a CD I am unable to boot the image
from the PC I wish to install it on. I can boot the image from my laptop
or any other system we have in the office but not the one I wish to
install it on. Was wondering if there is something weird about the .iso
file that perhaps looks for the CD drive being on the primary IDE
channel, and must be a slave etc... (Though I doubt this is the case..)
 
Is anyone else having the same problems?
 
As a process of elimination I've swapped out all the hard drives, and
used a few different CD drives in the system. (Samsung, ASUS, Diamond
(Mitsubishi)).
 
Cheers,
Francis McPhail
  
  _____  

Francis McPhail

Phone:

1300 13 55 48

Technical Services Manager

Fax:

1300 13 55 49

 

 

 

Blue Apache Pty Ltd

Direct:

03 8696 9305

Melbourne - Sydney

Mobile: 

0438 00 00 55

 

 

 

www.blueapache.com

Email:

francis.mcphail-mbwxT/[email protected]

  _____  

 

***********************************************************
It is confidential to the addressee and may contain certain copyright and/or legally privileged infomration.  No-one else other than, on behalf of the addressee, may read, print, store, copy, forward or act in reliance on all or any part of it or its attachments.  You must scan this email and any attached files for viruses.  We accept no liability for any loss, damage or consequence resulting either directly or indirectly from the use of attached files.