Re: YaST failure with SLES7

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

On Tuesday 16 July 2002 00:55, you wrote:
> On Mon, 2002-07-15 at 15:47, JÃŒrgen Henge-Ernst wrote:
> > the version shipped with SLES 7 has never been tested though with alice
> > and I added the full support later. So give the latest version a try and
> > check if that error still exists.
>
> 	I'll give it a whirl and see if it helps out, though I'm a bit
> skeptical as the switch from 0.9.2 to 0.9.4 made no noticeable
> difference.
yes that might be, but 0.9.5-11 is a very well tested an nearly bug-free 
version, that normally runs very smooth. The differenc between 0.9.4 and 
0.9.5 are very big.

>
> > There has also been a problem with yast and Compaq machines (might also
> > occur on other systems) where a update of yast was needed.
>
> 	I've seen this problem on a couple of generic machines and on Dell
> Poweredge 350s.  How would I update the version of yast that is used for
> the installer?
hm that's not very easy (I have never done it), you need to replace the files 
from within the yast-update-rpm on the installation server within the 
inst-sys directory and you mal also have to build a new ram-disk for that 
installation system. 

Greetings JÃŒrgen

- -- 
 Juergen Henge-Ernst // Hauptstrasse 37 // 67591 Mölsheim // Germany
           email: [email protected]        ICQ 56324358
Key fingerprint = 5FFD 89AC 6C7B 76DD 5FAC  9A3F D1A9 0C9B 3B49 67B1
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.0.6 (GNU/Linux)
Comment: For info see http://www.gnupg.org

iD8DBQE9NBMN0akMmztJZ7ERAlTuAKCqJbT4uN3TfUP52rALqOP1xNjEMQCgznEN
k8G1Xkq6O6EUsY4Kq2Qx5gc=
=XNBT
-----END PGP SIGNATURE-----


-- 
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]