Re: YaST failure with SLES7

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hi,
On Monday 15 July 2002 22:54, Daniel Thom wrote:
> 	I'm trying to setup ALICE to install SLES7 on a variety of machines
> using dhcp and NFS.  I first tried ALICE 0.9.2 which was provided with
> our copy of SLES7.  I had a problems with the number of inodes on the
> initrd, so I increased the number of inodes in the make_inst_disk
> script.  After that I was able to install a number of machines, but a
> few machines were giving me the following:
Have you tried the latest alice-release 0.9.5-11 from fabians site ??
http://www.suse.de/~fabian

the version shipped with SLES 7 has never been tested though with alice and I 
added the full support later. So give the latest version a try and check if 
that error still exists.

Greetings JÃŒrgen
> 	I am *STILL* seeing the YaST error I gave above, but I have noticed
> that it doesn't always happen.  I was able to install one of my machines
> and thought the problem was gone.  I went to install it again using the
> exact same floppy and it died this time.  Is there any way to get more
> information on what is happening?  I believe this is happening just
> after the last RPM is installed, but I couldn't be sure since the
> installer screen is cleared and I cannot find a useful log anywhere.
There has also been a problem with yast and Compaq machines (might also occur 
on other systems) where a update of yast was needed.

Greetings JÃŒrgen
- -- 
 Juergen Henge-Ernst // Hauptstrasse 37 // 67591 Mölsheim // Germany
           email: [email protected]        ICQ 56324358
Key fingerprint = 5FFD 89AC 6C7B 76DD 5FAC  9A3F D1A9 0C9B 3B49 67B1
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.0.6 (GNU/Linux)
Comment: For info see http://www.gnupg.org

iD8DBQE9M1D40akMmztJZ7ERAhu/AKCqcDvKdGxBoL9yCctVYrwjQ8wi6gCfT62W
/C1Z0GLh8khPkTEghPx8Drs=
=yBQX
-----END PGP SIGNATURE-----


-- 
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]