Re: Script update_rpms

no, I use update_rpms in ALICE_PRE_SCRIPT
I 've also tried it in SYS_APPLICATION_SCRIPTS
with the same result as described below.

Tom Becker


Jürgen Henge-Ernst schrieb:

> -----BEGIN PGP SIGNED MESSAGE-----
> Hash: SHA1
>
> On Wednesday 03 April 2002 15:27, Tom Becker wrote:
> > Hello
> >
> > I've inserted the scrip update_rpms in ALICE_PRE_SCRIPT.
> > (The other needed tag SYS_UPDATE_RPM_LOCATION is correct)
> > On first bootup it is called but does not seem to do anything. There is
> > no errormessage. About 30 seconds later booting goes on. During this
> > time
> > my server's HDD is not busy. After that all files have the same Version
> > than
> > before the "Update" was started.
> > The directory with the update-files is mounted correctly.
> > When I do the whole thing manually (ALICE_POST_SCRIPT)
> > the Syntax
> > mount <ip>:/directory/with/updated/files /Updates
> > for i in /Updates/*.rpm; do rpm -Uvh $i --force --nodeps;done;
> > works fine (even faster than rpm *.rpm).
> > But that is not the sense at all, if there is a special ALICE-tag
> > for this.
> >
> > Can anyone tell me a better solution or why it doesn't work with the
> > ALICE-Script?
> Are you using
> update_rpms in the tag SYS_APPLICATION_SCRIPTS ??
>
> Greetings Jürgen
>
> - --
> Jürgen Henge-Ernst                    Phone:  +49 (0)6196/50 95 1-32
> SuSE Linux AG                         Fax:    +49 (0)6196/40 96 07
> Mergenthaler Allee 45-47              Mobile: +49 (0)177 /26 74 748
> 65760 Eschborn, Germany               EMail:  [email protected]
> -----BEGIN PGP SIGNATURE-----
> Version: GnuPG v1.0.6 (GNU/Linux)
> Comment: For info see http://www.gnupg.org
>
> iD8DBQE8rBlGwIwzBbM848kRAqQiAKCFLazwzKKd6w8Az3cEMXsLAH8ezgCgnhl0
> qdWs2FRdIwxB1o72jIm4G2c=
> =+65+
> -----END PGP SIGNATURE-----


-- 
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]