Blinux and USB displays

Hi all,
OK, so I have done a few tests here changing my Brailliant 40 display to=
 use the Handytech protocol over USB. It works fine if I connect it to my=
 serial port, but not over USB. The installation program seems to boot just=
 fine, but no braille output over USB. So USB doesn't seem to work, or=
 isn't the Handytech protocol supported on USB?
If so, that would be very strange.
Any comments on this would be really apreciated.
Many thanks,
Christian

-- 
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]