Re: Blinux and USB displays

hi,
On Sun, 15 Mar 2009, Christian wrote:

> Hi all,
> my serial port, but not over USB. The installation program seems to boot just
>  fine, but no braille output over USB. So USB doesn't seem to work, or 
> isn't the Handytech protocol supported on USB?
> If so, that would be very strange.
> Any comments on this would be really apreciated.
handytech is supported via USB - the handytech displays yre using 
a standard FTDI chip to convert serial to USB
please send me the lsusb output
when your braille display is connected via USB
maybe the internal converter is not supported or your display returns a 
none-handytech ID byte over USB

thanks

marco

> Many thanks,
> Christian
>
> --
> To unsubscribe, e-mail: [email protected]
> For additional commands, e-mail: [email protected]
>

------------------------------------------------------------
Marco Skambraks
SUSE LINUX Products GmbH,  Maxfeldstr. 5,  D-90409 Nuernberg
T:   +49 (0) 911 74053-0
Fax: +49 (0) 911 74053-483             [email protected]
------------------------------------------------------------
** life is hard and then you die **
-- 
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]