Re: USB camera

Sorry,
my system is SuSE 7.3

On Tue, 01 Apr 2003 12:56:08 +0300
  "Yuriy Chumak" <[email protected]> wrote:
> Hello.
> I can't mount my camera (Olympus C-220Z, USB) by follow command:
> mount -t vfat /dev/sda1 /media/usb
> 
> device /dev/sda1 isn't present
> What I do wrong?
> 
> 
> kernel: hub.c: USB new device connect on bus1/1, assigned device number 2
> kernel: usb.c: USB device 2 (vend/prod 0x7b4/0x102) is not claimed by any 
> active driver.
> kernel: Initializing USB Mass Storage driver...
> kernel: usb.c: registered new driver usb-storage
> ync kernel: scsi0 : SCSI emulation for USB Mass Storage devices
> kernel: usb.c: USB disconnect on device 2
> kernel: usb_control/bulk_msg: timeout
> kernel: scsi: device set offline - not ready or command retry failed after 
> bus reset: host 0 channel 0 id 0 lun 0
> kernel: usb_control/bulk_msg: timeout
> insmod: Using 
> /lib/modules/2.4.10-4GB/kernel/drivers/usb/storage/usb-storage.o
> insmod: Symbol version prefix ''
> kernel: WARNING: USB Mass Storage data integrity not assured
> kernel: USB Mass Storage device found at 2
> kernel: USB Mass Storage support registered.
> kernel: hub.c: USB new device connect on bus1/1, assigned device number 3
> kernel: scsi1 : SCSI emulation for USB Mass Storage devices
> modprobe: modprobe: Can't locate module block-major-8
> modprobe: modprobe: Can't locate module block-major-8
> ----
> http://photo.alkar.net
> 
> -- 
> To unsubscribe send e-mail to [email protected]
> For additional commands send e-mail to [email protected] 
>             

----
http://photo.alkar.net