Re: Scanning as user?

Hello,
my Problem was the rights management ... try before using yast ... chmod
777 /dev/sg3 ... maybe now the user have access ... but you need to set
the access with every reboot ...

hth

OLI

Am Son, 2003-07-27 um 01.40 schrieb Christof Schmitt:
> Hello list,
> 
> after a 'insmod advansys' command in '/etc/init.d/boot.local' the 
> Advansys-Card works (as 'cdrecord --scanbus' shows). That's allright. 
> 
> But if i want to work with the scanner, i have to "install" the scanner with 
> YAST -> Hardware -> scanner as ROOT (immediatly after YAST -> Hardware -> 
> scanner YAST shows the right scanner as 'installed' - strange, but that the 
> fact). After that i (as USER) can use the scanner by GIMP. Shutting down the 
> system there is the message: 'Resetting /dev/sg3' (or similar text - /dev/sg3 
> is the scanner) and after the next boot i have to "install" the scanner 
> again.
> 
> What i have to do, if i want to use the scanner as user (maybe) by booting the 
> system? And is there a way to pre-install the scanner? YAST or the system 
> seems to loose the settings while shutting down.
> 
> best regards,
> 
> Chris
-- 
Tim Oliver Wagner <[email protected]>