SUSE9.3 and Terratec Cinergy 400

Hi

I run SUSE9.3 and I use the TV card from Terratec Cinergy 400.
Through YAST the card is detected but when I scan the channels nothing is 
being found.
In the syslog I have the below listed entries

Does anybode know what is wrong here and how can I fix it?

May  8 16:44:29 apus kernel: saa7133[0]: found at 0000:03:00.0, rev: 240, irq: 
10, latency: 0, mmio: 0x40800000
May  8 16:44:29 apus kernel: PCI: Setting latency timer of device 0000:03:00.0 
to 64
May  8 16:44:29 apus kernel: saa7133[0]: subsystem: 153b:1162, board: Terratec 
Cinergy 400 TV [card=8,insmod option]
May  8 16:44:29 apus kernel: saa7133[0]: board init: gpio is 40000
May  8 16:44:29 apus kernel: saa7133[0]: registered input device for IR
May  8 16:44:29 apus kernel: saa7133[0]: dsp access wait timeout [bit=WRR]
May  8 16:44:29 apus kernel: saa7133[0]: dsp access wait timeout [bit=WRR]
May  8 16:44:30 apus kernel: saa7133[0]: i2c eeprom 00: 3b 15 62 11 08 20 1c 
55 43 43 a9 1c 55 43 43 a9
May  8 16:44:30 apus kernel: saa7133[0]: i2c eeprom 10: 00 ff e6 07 00 00 00 
00 00 00 00 00 00 00 00 00
May  8 16:44:30 apus kernel: saa7133[0]: i2c eeprom 20: 01 00 02 02 01 3e 9b 
cb 91 03 03 00 07 00 01 00
May  8 16:44:30 apus kernel: saa7133[0]: i2c eeprom 30: 00 02 02 00 00 00 00 
00 00 00 00 00 00 00 00 00
May  8 16:44:30 apus modprobe: FATAL: Error inserting tuner 
(/lib/modules/2.6.11.4-20a-default/kernel/drivers/media/video/tuner.ko): 
Unknown symbol in module, or unknown parameter (see dmesg) 
May  8 16:44:30 apus kernel: tuner: Unknown parameter `tuner'
May  8 16:44:30 apus kernel: load_module: err 0xfffffffe (dont worry)
May  8 16:44:30 apus kernel: saa7133[0]: registered device video0 [v4l2]
May  8 16:44:30 apus kernel: saa7133[0]: registered device vbi0

--
Any help is very much appreciated.
Sami