Re: Re: openSUSE 12.3 PowerPC for the AmigaOne X1000
Alexander Graf <[email protected]>
| Newsgroups | gmane.linux.suse.ppc |
|---|---|
| Message-ID | <[email protected]> |
Sure :). You could also create a tar based kiwi configuration and have obs build it, like we do for arm. Then you can use that as rootfs for your system. Alex Am 02.10.2013 um 21:21 schrieb Christian Zigotzky <[email protected]>: > Hi Alex, > > Is it possible to install openSUSE 32-bit over QEMU on a USB stick and then boot it with a 64-bit kernel on an AmigaOne X1000? > > Best regards, > Christian > > Am 02.10.13 19:44, schrieb Alexander Graf: >> On 02.10.2013, at 19:31, Christian Zigotzky wrote: >> >>> Am 02.10.13 19:18, schrieb Alexander Graf: >>>> On 02.10.2013, at 19:05, Christian Zigotzky wrote: >>>> >>>>> Hi there, >>>>> >>>>> I've tried to install openSUSE 12.3 on my AmigaOne X1000. Unfortunately the installation of a lot of 64-bit packages failed. Issue: scriptlet failed, signal 11. >>>> 64-bit packages won't work because the PA6T is not compatible (enough) to POWER4 which is the minimum requirement for 64-bit openSUSE 12.3 to work. >>>> >>>> >>>> Alex >>> Hi Alex, >>> >>> Thank you for your answer. Can I install a 32-bit openSUSE 12.3 system? Or is openSUSE 12.2 compatible with my PA6T? >> Sure! As long as you don't use 64-bit binaries, a 32-bit 12.3 system should work just fine on PA6T. >> >> >> Alex > > -- > To unsubscribe, e-mail: [email protected] > To contact the owner, e-mail: [email protected] > -- To unsubscribe, e-mail: [email protected] To contact the owner, e-mail: [email protected]